HAM WeatherSense
The HAM WeatherSense is a weather station for outdoor sites. It measures temperature, humidity, wind, rain, pressure, solar radiation, noise and air quality.
The serial number starts with e44:.
The device is not in the shop. For installation and availability, contact us. See contact support.
What it measures
Section titled “What it measures”| Reading | Unit | Note |
|---|---|---|
| Temperature | °C | |
| Humidity | % | Relative humidity. |
| Wind Speed | m/s | |
| Wind Direction | ° | |
| Barometric Pressure | hPa | |
| Rain (Total) | mm | |
| Rain | mm/h | The rain rate. |
| Solar Radiation | W/m² | |
| Noise level | dB | |
| PM2.5, PM10.0 | μg/m³ | Particles in the air. |
| CO₂ Concentration | ppm | |
| Luminosity | lux |
Typical uses
Section titled “Typical uses”- Farms and greenhouses, for the conditions outside.
- Construction sites and outdoor workplaces.
- Municipalities and schools, for environmental readings.
Installation
Section titled “Installation”Connect the device to WiFi from the mobile app. See WiFi setup. The WiFi signal must reach the installation point.
Settings
Section titled “Settings”In Settings > Advanced:
- Allow LAN commands: other devices on your local network can control this device. Keep the setting off if you do not need it.
- Force IPv4: the device connects with IPv4 only.
The general settings of all devices are in device settings.
Recommended rules
Section titled “Recommended rules”The Recommended setups button on the device page suggests:
- An alert when the temperature goes out of range.
- An alert when the humidity goes out of range.
- An alert when the device stops sending data.
You can also make your own rule, for example for strong wind or rain. See create a rule.
Troubleshooting
Section titled “Troubleshooting”- The device is offline: check the WiFi signal at the site. See device offline.
Specifications
Section titled “Specifications”| Connectivity | WiFi 2.4 GHz |
| Marks | CE, WEEE, RoHS |