HAM DualSwitch
The HAM DualSwitch is a switch with two outputs that you control from the app. It does not measure energy.
The serial number starts with 16:. It is a device of the older generation.
Typical uses
Section titled “Typical uses”- Control of two separate loads.
- A motor with up and down direction, with the Only one output active at the time setting.
Installation
Section titled “Installation”You connect the device to WiFi from the mobile app. Select HAM DualSwitch in the list.
- Supply power to the device.
- Wait until the LED starts to blink. The device has no setup button.
- Continue with the steps in Connect to WiFi.
When the device is connected, the blue LED goes off. See LED states.
Terminals and protection
Section titled “Terminals and protection”- 1: neutral. 2: line in. 3: line out A. 4: line out B.
- 5: switch A. 6: switch B. 7: common of the switches.
- The device goes inside an electrical box. It is for lighting or electric shutters.
- The device has no overload protection.
Settings
Section titled “Settings”- Only one output active at the time: the two outputs are never on together.
- Push Button Mode: turn it on when you use push buttons for local control.
- Disable manual control: control from the device, for example from its buttons, is disabled.
- Do not keep track of data: the platform keeps no history for the device.
- Allow LAN commands: other devices on your local network can control this device. Keep the setting off if you do not need it.
General settings for all devices are in Device settings.
Controls
Section titled “Controls”The device has two outputs, Out Up and Out Down. You turn them on and off from the device page. See Controls.
On the device page, tap Edit and then Settings on an output. There you set:
- Auto turn-off: the output turns off after the time that you set. The value 0 disables it.
- Power on value: the output state when the power comes back, off or on.
- Confirm output changes: the app asks for confirmation before it changes the output.
- PIN Code: the app asks for a PIN before it changes the output.
In the Notifications and Automation section of the page you find:
- Schedule: up to 6 schedules for the outputs. See Schedules.
- Local rules: 2 rules that run on the device without a cloud connection.
Troubleshooting
Section titled “Troubleshooting”- The device does not connect to WiFi: make sure that the router transmits on 2.4 GHz with a 20 MHz channel. See WiFi setup fails.
See also Device offline.
Specifications
Section titled “Specifications”| Outputs | 2 (A and B), each 5 A for a resistive load or 2 A for an inductive load |
| Connectivity | WiFi 2.4 GHz, 20 MHz channel |
| Power supply | 230 VAC, less than 2 W |
| Operating temperature | -10 to 50 °C |
| Dimensions | 48.4 x 40.0 x 20.1 mm |
To buy, see the shop.