HAM PressureSense
The HAM PressureSense measures the pressure in a pipe or a water network. Use it when you want to know at once if the pressure drops or rises.
The serial number starts with e37: (HAM PressureSenseS). The older version starts with 37:.
What it measures
Section titled “What it measures”| Reading | Unit | Note |
|---|---|---|
| Pressure | MPa | 1 MPa = 10 bar |
| Gen. In., Gen. In. 2 | Two general inputs. They show when you configure them |
Settings
Section titled “Settings”The settings are on the device page, in the Settings section. For the general procedure see Device settings.
- Pressure Sensor Range: the maximum pressure of the sensor in MPa. The default is 1. Set the value that is written on your sensor.
- Device Description: text that shows as a subheading in reports.
- Allow LAN commands (in Advanced): other devices on your local network can control this device. Keep the setting off if you do not need it.
- Force IPv4 (in Advanced,
e37:only): the device uses only IPv4 connections. - Do not keep track of data (in Advanced): the app keeps no reading history.
Recommended rules
Section titled “Recommended rules”The app has no ready-made rules for this device. Create at least these:
- An alert when Pressure drops below a limit.
- An alert when Pressure goes above a limit.
- An alert when the device goes offline. See Offline alerts.
For the steps see Create a rule.
Installation and availability
Section titled “Installation and availability”The device connects to WiFi 2.4 GHz (Connect a device to WiFi). For installation and availability, contact us.